The most important points of weaving in the carpet threading

• One of the most important points in the practice of threading is to pay attention to the fact that it should be done completely in the middle and so that the two sides are symmetrical so that the weight of the pulls is not transferred to one side.
• The tension of the warp yarns in all widths should be uniform and equal.
• Since the distance between the strings is usually equal to the diameter of the thread used, be careful to pull between 4 and 5 strings normally per centimeter.
• The thread pulling operation should not be done with a lot of traction, but for better quality, the thread pulling should be done with a medium and proportional stretch, so it is better if you do not have enough experience in this field, leave it to a specialist.
• Another important point in thread pulling is to check the evenness of the number of strands stretched.

After the weaving stage, it is time to curl, in short, this operation is actually the same as weaving, which is done by passing several strands of weft yarn to smooth and order the wefts and its strength. After knitting and weaving, chain weaving or so-called garlic weaving should be started, which will prevent the beginning and end of the carpet from breaking and tearing when using the carpet.

One of the most important factors in the success of a good weave is the precision in pulling the thin fabric, so it is best not to start weaving at all before making sure of this. Remember that the texture quality of any carpet is more than anything related to the quality of its thin weave.
The important point in doing all the steps described is that doing them requires the necessary and sufficient expertise and skills, so if you want the final quality of the carpet to be high, it is better to do these steps by experts if necessary.

Precise control of carpet height

In order to prevent problems and defects that may occur due to lack of dimensional control, it is better to regularly, although once, the texture height is calculated in proportion to the number and then checked in the texture, if the carpet height is adjusted from the beginning. Many problems will be prevented. However, you may still experience problems such as dents or bumps during weaving, which are explained below.

If you notice tissue degeneration while working, you should pay attention to the following points

• It is possible that you have beaten the drum too hard, remember that you must always apply the right amount of pressure to use the drum.
• You may have forgotten to use thick fabric and thin fabric regularly in each ridge.
• Excessive tightening of the bolts by the screws or pulling them more open than standard may also cause this problem.

Sometimes you may encounter the problem of raised work while weaving the carpet, in which case you also need to know the following points

• You may have beaten it slowly and less than standard.
• Loose joints can also lead to overwork, to solve this problem, you can tighten them evenly through the screws.
• If you pull the thin fabric too tight and dry, with each blow, the next ridge will not go down to a sufficient and standard level and will lead to a rise in the tissue.
• High density of wefts will be another cause of tissue overgrowth.

The important point is that it is better to prevent the creation of bumps or bumps by considering the necessary points in the carpet texture, but if you encounter these problems, the worst decision to compensate for it is to make the rest of the work too short or long, so If you encounter these cases, it is better to weave the rest of the carpet according to the standard sizes of the table.
The next point is that to avoid yarn deficit, you should always use standard knots with a length of three centimeters, because sometimes it is not possible to continue the texture of the carpet and your efforts will be wasted.

The last point that we remind you is that after weaving each ridge, be sure to knit the knots with two fingers so that the knots are completely smooth and stretched in the carpet structure. Comb the knots. Note that combing the fabric with a brush is a necessary task for carpets that are to be embossed.